| Note |
|---|
We assume that the hard- and software infrastructure for just:live has already been set up by the time you are reading this page. If this is not the case, refer to [v5] the just:live v.4 5 Getting Started Chapter or contact your system administrator. |
...
To use just:live you need to connect to a Channel a Channel using the Just Control application.
Go to your Applications folder and open the folder Just Playout folder.
Open the Application Just Control application. The Login window shows up.
Enter the username and password. Consult your system administrator if you don’t know these credentials.
Optional: select Select a Multi - viewer layout. It may be the case that this menu only allows you to select the Default “Default” layout.
Click the Loginon the “Login” button to start enter Just Control. The Multi - viewerwindow is shown with all channels Channels available for the selected user.
Click on the “Open Interface” button in the middle of the screen (marked in red in this figure) of the channel Channel you would like to work withoperate.
The corresponding channel will be opened and the just:live interface shows will show up. As you can see a tab A tabbed bar is now showndisplayed, allowing you to switch back to the Multi - viewerwindow, or closing close the previously opened just:live user interface. Note Please note that when closing the UIuser interface, the playout will continue to run, unless the Just Out and/or Just Connect applications are terminated quit as well.
