| Note |
|---|
You must unlock the Just Control Configuration window and stop the channel(s) first to be able to make perform any changes. |
Stopping and starting an Engine
To be able to do changes to an Engine modify a Just Out engine or a Channel, it needs to be stopped first. This can be done by stopping the Channel, even in case if the Just Out engine is running on another machine.
Stop an engine: Stop the desired Channel by deactivating the checkbox in front of it. Stopping a Channel will also stop the Primary Just Out engine and therefore the final output.
| Info |
|---|
The Just Out engine will automatically restart in idle mode and wait for the operator to start the channel Channel again. |
Start an engine: Start the desired Channel by activating the checkbox in front of it. Starting a Channel will also start the Just Out engine and therefore the playout will resume.
Once done, close the configuration window Just Control Configuration panel and drag the Channel from the “Connections” tab to the Multi - viewer area.
...
Deleting an Engine
Deleting an a Just Out engine entry is useful in situations where an existing engine will be replaced by a new engine running on another machine.
Stop the desired Channel by deactivating the checkbox in front of it. Stopping a Channel will also stop the Main Just Out engine and therefore the final output.
Select the Channel in the “Devices & Channels Channels” list.
Click on the “Layers & EnginesEngines” tab.
Select an existing engine and choose choose “Delete engine engine” in the just “just:out EngineEngine” column.
...