...
Use the menu command “Channels → Show Configuration Pane” to open the Just Control Configuration Panel panel.
Alternatively, you can use the “Connections” tab in the Inspector. Clicking the “Configure” button or double-clicking a Device in the list opens the Just Control Configuration window.
...
Just Control Configuration Window Overview
The Just Control Configuration panel consists of two different areas:
...
Devices & Channels (1)
Displays all currently connected Devices and the corresponding Channels.
...
Unlock the panel by entering the administrator password. Press the “Plus ” button ("Add Device") below the “Devices & Channels” list to add a new Device. Enter the “IP - Address” of the machine running the Just In Engine application. The default port (5000) is usually correct unless your network administrator specified a different one (when you are running the engine locally, the IP-Address is already entered). Press the “Add” button to establish the connection.
...
When connecting a Device for the first time, a Device Wizard willhelp you with the basic configuration and settings. First, select either “Configure device with the detected physical inputs”, if you want to set up a Just In Engine for use with SDI or HDMI inputs, or choose “Configure device for streaming inputs (e.g. NDI®5) with the following formatformat”, if you would like to set up a Just In Engine with streaming input(s) only.
Info |
---|
Please note, that you can add NDI®5 inputs at any time, independent of the Device Wizard process. |
If you select “Configure device with the detected physical inputs”, press the “Scan” button to detect all available input cards (AJA or Blackmagic Design video device driver installation required). Choose Select the Video Mode (“SDI (AJA or Blackmagic Design)”) and the Video Format (e.g. “1080i25”) and proceed to the Device and Channel Name. Define a Default Storage Path (Destination Preset) and filter and select Capture Presets from the list below. Press the “Configure” button to finish the Device Wizard setup process.
...
Remove Devices
A connected Device can be removed from the “Devices & Channels Channels” list by using the Minus (“-”) button.
...
Green light indicator: a Device is connected successfully and the Just In Engine application is running
Red light indicator: a Device is not connected (e.g. wrong IP - Address) or the engine is not running.
...
The Device name can only be changed when there is no Channel enabled. To do so, double-click the Device Name (beside next to the Device Status), adjust the Name, and press enterthe “Enter” key to confirm.
...
Info |
---|
You can drag & drop devices within the “Devices & Channels” list to reorder the Devices. |
...