Introduction

Once the just:in linux appliance is wired installed and set up (power, network, video signals) and set up (network) correctly, it is possible to connect to the just:in linux server and to start with the initial setup. In order to To achieve that, the following steps are required:

• Check the IP-Address, which will be used for the communication between the just:in linux server and the macOS-based Just Control application.

• Install Just Control on a macOS-based client system, which has access to the just:in linux appliance (via the network).

• Establish the connection to the just:in linux appliance with he the macOS-based Just Control client application.

IP-Address

Normally Generally, the just:in linux appliance has multiple network connections. One gets used is for communication purposes, such as interacting with just:control Just Control and another one will be used for the storage system connection. To access the just:in linux server with the macOS-based Just Control application, the IP - Address of the communication port is required (normally the “em1” Ethernet interface is normally used for that purpose).

Installation (Just Control)

If there is currently Should temporarily no internet access on your systemconnection be available, copy themacOS-based Just Control application from the internal just:in linux RAID to the macOS Applications “Applications” folder. Therefore To do so, mount the internal just:in linux RAID on a macOS-based system (via “Finder -> Go -> Connect to Server” or with the Finder keyboard shortcut “Command-K”). Type in the IP - Address of the just:in linux appliance, enter the credentials (User: justin, Password: justin), and select the tools share point. The Just Control application can be found here.

...

You Alternatively, you can access the just:in linux appliances via ssh as well to copy the Just Control client application. The internal RAID is mounted at the following path.

# internal raid
/media/internal_raid/

# just:control application
/media/internal_raid/tools

Usage (

...

Just Control)

Go to the macOS “Applications” folder and open Just Control application.Press the “Login” button to continue.

...

Enter the IP - Address of the just:in linux appliance and press the “Connect” buttonto start the Setup Wizard.

...

Choose “Configure device with the detected physical input(s)” and press the “Scan” button to display the available SDI or HDMI inputs.

Then select the Video Mode (SDI (AJA)) and the Video Format (e.g. 1080i25) for the Device Inputs. Enter the Device Name and Channel Name, as well as the Default Storage Path. These settings can be changed later again , if needed. As a last step, filter the available Capture Presets and select at least one of these the available presets. To finish the set up setup process, press the Configure “Configure” button.

...

After a few seconds, all available inputs will be connected to the multi-viewer and if there is a valid signal on the SDI inputs, the channel viewer(s) display the video, audio, and timecode previewpreviews.

...

Now the channels are The Channel(s) are now ready for recording. Move the mouse into a Channel Viewer and press the Record “Record” button to start the recording Recording. Press the same button again to stop the recording Recording.

...