| Note |
|---|
You must unlock the Just Control Configuration window and stop the channel(s) to be able to make any changes. |
After using the New Channel Wizard an engine is automatically created and added to all Layers of the Channel, but there can be situations where you would like to check or even change the attributes of an existing engine.
...
Changing the Attributes of an Existing Engine
| Note |
|---|
You must unlock the Just Control Configuration window and stop the channel(s) to be able to make any changes. |
Stop the desired Channel by deactivating the checkbox in front of it. Stopping a Channel will also stop the Just Out engine and therefore the final output.
Select the Channel in the Devices & Channels list.
Click on the Engines & Layers tab.
On one of the desired Layers, open the drop-down menu in the column Primary or Redundant just:out Engine and select Configure engine.
You change now engine attributes like described below.
...