This chapter explains describes the Channel Settings for a just:in mac channel and how to enable a Channel for Recording, once it has been configured.
| Info |
|---|
To make any changes, you have to unlock the Configuration Panel at the bottom left first. |
What is a Channel?
A Channel is a virtual representation of a Video Device or a NDI Source within the network. Depending on the number of inputs, you may can configure one or multiple Channels.
...
| Info |
|---|
Depending on your Video device(s) the Channel Settings may can look slightly different. |
...
Settings
...
Input: Choose the Input of the Device for this Channel here.Video/Audio Input, Sampling: select the Video/Audio input if your
Video device supports different inputs and select the audio sampling option.Video Mode: select the Video mode. The mode has to match the Video Signal, which is attached to the selected Channel. If it does not match, a warning will be shown (No Signal). Beware that here are only video modes available, which are matching the Device Frame rate.
...
Calendar: select the Calendar which you would like to use with this Channel for Scheduled recordings. You may use any Calendar which can be imported to Apple Calendar app. This can be a local Calendar like the one which was created by the just:in Channel or an iCloud or Gmail Calendar. Contact us for more information.
Preview
You can manually override the resolution, framerate and the quality of the Video Previews within just:control. This may be helpful to increase performance when displaying many Channels in just:control. Please see Channel Preview Options below for more informations.
...
Quality: can be changed between 10 and 100%.
Channel Settings NDI
...
...
| Info |
|---|
The NDI source can be selected within the Channel Inspector. |
Video Mode: select the Video mode. The mode has to match the NDI Source. If it does not match, a warning will be shown (No Signal). Beware that here are only video modes available, which are matching the Device Frame rate.
...
| Info |
|---|
Once a channel is enabled, it will be available in the Connection Tab within the Inspector. |
Change a Channel Name
The Name name of a Channel can only be changed, when the Channel is disabled. First make sure that the Channel is not enabled and then double- click on the Channel Name (next to the channel checkbox), adjust the name and press enter.
...