...
Adding an Event Device in Just Control Configuration
- Select the desired Channel.
- Activate the Events tab.
- Event device and protocol: Select the desired type of Router here. Some Routers may use the same protocol but are from different manufacturers. Make sure to select a protocol which is supported by your Router. If you are unsure about which protocol to use, ask the manufacturer or send a request to our support system. If a device supports only a certain setting please contact ToolsOnAir for assistance.
- Timeout/Delay in seconds: For some devices a timeout can be defined here.
- Serial port: Select and configure a serial connection. Check the user manual of your Router to find more information about the proper settings. If you are unsure about which settings to use, ask the manufacturer of the hardware device.
- Ethernet: Configures an Ethernet connection. If your device supports network communication, configure the Ethernet connection here. This method is preferred and should be used whenever possible. If a device supports only a certain setting please contact ToolsOnAir for assistance.
Click on the Add… button to add the selected device to the list of Currently event devices of the Channel.
...