...
- Capture Devices (left side): lists supported Video capture devices. Click on a device to configure itSelecting a device in this list will show the Settings on the right.
- Name: the desired Channel name, which will also be displayed in the just:in user interface.
- Device Serial Number: shows the device serial number.
- Video Mode: select the Video mode.
- Video/Audio Input: select the Video/Audio input.
- Audio Bitrate: select the Audio bitrate (native 24-bit for AJA, selectable 16- or 24-bit for Blackmagic).
- VTR Control: select the serial RS-422 connection you want to use to control your VTR.
- VTR Preroll in Seconds: set the desired VTR preroll value in seconds (1-10).
- Chunk Length: Defines defines the maximum length of the Container. The maximun Chunk Length is 12 hours.
- If the recording When Recording does not reach the entered Chunk Length, the : clips will be automatically truncated to the expected recorded length.
- If the recording When Recording exceeds the entered Chunk Length, : a new recording Recording (generating a new clip) will automatically be started.When recording in Crash Mode, clips will be added after the maximum record length has been reached.
- Start Timecode: enabling this option makes every new clip start with the defined timecode value.
- Cache Options:
- Don't Cache (default): usually files files are directly written to disk in a stream (, no caching , default)is done.
- Cache: you can tell tells the storage controller to cache data in order to flush them later it to disk later to improve write performance. If you experience low write performance, enable caching.
- Video Output Buffer (QuickTime only): Number number of A/V frames to flush to the storage system at once. If you want to flush once a second, just enter your the Video framerate.
- Output Buffer Segments (QuickTime only): Number number of buffer segmentsBuffer Segments. The number Number of segments Buffer Segments multiplied by the Video Output Buffer (= storage flush size) is the total buffer size. We recommend not to exceed a total buffer size of 250 frames, otherwise the system may run out of RAM.
- Action on Timecode break:
- Ignore: Channel ignores timecode breaks.
- Create new file: Channel creates a new file upon a timecode break.
- Engine Port: port to access the Channel from just:in over an IP connection. Default is 50000.
- Communication Interface: select the network interface which should be used for establishing a connection to the just:in user interface.